A wooden slat base with beaded support strands hanger replaces traditional bottom rope knots with a solid, circular hardwood platform to provide a perfectly level, wobble-free foundation for potted plants. Traditional knot-cradle hangers can sometimes shift if a ceramic pot is asymmetrical, causing water spills during routine plant care. This hybrid design uses a flat, six-inch circular wooden craft plaque or slice of kiln-dried hardwood drilled with four perimeter suspension holes. The four beaded cords pass directly through the wooden base plate, supporting the flat wooden tray from below. This configuration allows you to lift potted plants on and off the hanging shelf effortlessly without untangling rope cradles, while the beaded suspension arms provide whimsical vertical framing overhead.

To build this platform hanger, sand a six-inch-diameter, three-quarter-inch-thick solid birch wood disc smooth, sealing the timber with two coats of clear waterproof polyurethane. Drill four evenly spaced five-sixteenths-inch holes one-half inch inward from the outer perimeter of the wood disc using a spade bit. Cut four eight-foot lengths of four-millimeter braided cotton cord, securing them through a two-inch wooden top ring with a wrapped gathering knot. Thread ten twenty-five-millimeter natural wooden beads onto each of the four individual cords, sliding the beads up to sit snugly beneath the top ring before tying an overhand stop knot beneath each bead column. Thread the free end of each cord through one of the four holes in the wooden platform disc, pulling the cords until the platform rests level. Tie a secure, heavy double-overhand knot beneath each hole on the underside of the wooden disc, threading three accent beads onto each tail before trimming the cords into decorative mini-tassels.