Unspooling baker’s twine, embroidery thread, or heavy button thread can quickly turn into a tangled knot inside craft totes. This dispenser project punches a smooth grommeted hole in the top of the pill bottle cap, allowing thread or twine to pull out smoothly while the spool remains protected inside.
Wrapping the exterior in rustic jute twine, baker’s twine, or kraft paper adds a cozy handmade aesthetic.
+-------------------------------------------------+
| GROMMETED THREAD DISPENSER |
| |
| ( Grommet Exit Hole ) |
| [ PILL BOTTLE TOP CAP ] |
| ========================= |
| | JUTE / KRAFT WRAPPED | |
| | EXTERIOR BARREL | |
| | | |
| | ( Thread Spool ) | |
| | \ | |
| | \--> Feeds Up | |
| +-----------------------+ |
+-------------------------------------------------+
Step-by-Step DIY Instructions
- Drill Lid Hole: Drill a 1/4-inch hole in the center of the pill bottle cap using a hand drill or heated metal craft punch.
- Insert Small Grommet: Press a small metal or rubber eyelet/grommet into the hole to prevent plastic edges from fraying thread.
- Wrap Exterior: Wrap the exterior barrel in spiral rows of natural jute twine using hot glue to secure the ends.
- Load Spool: Place a thread spool or ball of twine inside the bottle, feeding the lead thread end upward through the cap grommet.
- Pull & Cut: Snap the lid shut and pull thread smoothly on demand.
